Memory is the electronic holding place for the instructions and data a computer needs to reach quickly. It's where information is stored for immediate use. Memory is one of the basic functions of a computer, because without it, a computer would not be able to function properly. Memory is also used by a computer's operating system, hardware and software. There are technically two types of computer memory: primary and secondary. The term memory is used as a synonym for primary memory or as an abbreviation for a specific type of primary memory called random access memory (RAM). This type of memory is located on microchips that are physically close to a computer's microprocessor. If a computer's central processer (CPU) had to only use a secondary storage device, computers would become much slower. In general, the more memory (primary memory) a computing device has, the less frequently the computer must access instructions and data from slower (secondary) forms of storage.Memory vs. storage The concept of memory and storage can be easily conflated as the same concept; however, there are some distinct and important differences. Put succinctly, memory is primary memory, while storage is secondary memory. Memory refers to the location of short-term data, while storage refers to the location of data stored on a long-term basis. Memory is most often referred to as the primary storage on a computer, such as RAM. Memory is also where information is processed. It enables users to access data that is stored for a short time. The data is only stored for a short time because primary memory is volatile, meaning it isn't retained when the computer is turned off. The term storage refers to secondary memory and is where data in a computer is kept. An example of storage is a hard drive or a hard disk drive (HDD). Storage is nonvolatile, meaning the information is still there after the computer is turned off and then back on. A running program may be in a computer's primary memory when in use -- for fast retrieval of information -- but when that program is closed, it resides in secondary memory or storage. How much space is available in memory and storage differs as well. In general, a computer will have more storage space than memory. For example, a laptop may have 8 GB of RAM while having 250 GB of storage. The difference in space is there because a computer will not need fast access to all the information stored on it at once, so allocating approximately 8 GB of space to run programs will suffice. The terms memory and storage can be confusing because their usage today is not always consistent. For example, RAM can be referred to as primary storage -- and types of secondary storage can include flash memory. To avoid confusion, it can be easier to talk about memory in terms of whether it is volatile or nonvolatile -- and storage in terms of whether it is primary or secondary. How does computer memory work? When a program is open, it is loaded from secondary memory to primary memory. Because there are different types of memory and storage, an example of this could be a program being moved from a solid-state drive (SSD) to RAM. Because primary storage is accessed faster, the opened program will be able to communicate with the computer's processor at quicker speeds. The primary memory can be accessed immediately from temporary memory slots or other storage locations. Memory is volatile, which means that data in memory is stored temporarily. Once a computing device is turned off, data stored in volatile memory will automatically be deleted. When a file is saved, it will be sent to secondary memory for storage. There are multiple types of memory available to a computer. It will operate differently depending on the type of primary memory used, but in general, semiconductor-based memory is most associated with memory. Semiconductor memory will be made of integrated circuits with silicon-based metal-oxide-semiconductor (MOS) transistors. Types of computer memory In general, memory can be divided into primary and secondary memory; moreover, there are numerous types of memory when discussing just primary memory. Some types of primary memory include the following Cache memory. This temporary storage area, known as a cache, is more readily available to the processor than the computer's main memory source. It is also called CPU memory because it is typically integrated directly into the CPU chip or placed on a separate chip with a bus interconnect with the CPU. RAM. The term is based on the fact that any storage location can be accessed directly by the processor. Dynamic RAM. DRAM is a type of semiconductor memory that is typically used by the data or program code needed by a computer processor to function. Static RAM. SRAM retains data bits in its memory for as long as power is supplied to it. Unlike DRAM, which stores bits in cells consisting of a capacitor and a transistor, SRAM does not have to be periodically refreshed. Double Data Rate SDRAM. DDR SRAM is SDRAM that can theoretically improve memory clock speed to at least 200 MHz. Double Data Rate 4 Synchronous Dynamic RAM. DDR4 RAM is a type of DRAM that has a high-bandwidth interface and is the successor to its previous DDR2 and DDR3 versions. DDR4 RAM allows for lower voltage requirements and higher module density. It is coupled with higher data rate transfer speeds and allows for dual in-line memory modules (DIMMS) up to 64 GB. Rambus Dynamic RAM. DRDRAM is a memory subsystem that promised to transfer up to 1.6 billion bytes per second. The subsystem consists of RAM, the RAM controller, the bus that connects RAM to the microprocessor and devices in the computer that use it. Read-only memory. ROM is a type of computer storage containing nonvolatile, permanent data that, normally, can only be read and not written to. ROM contains the programming that enables a computer to start up or regenerate each time it is turned on. Programmable ROM. PROM is ROM that can be modified once by a user. It enables a user to tailor a microcode program using a special machine called a PROM programmer. Erasable PROM. EPROM is programmable read-only memory PROM that can be erased and re-used. Erasure is caused by shining an intense ultraviolet light through a window designed into the memory chip. Electrically erasable PROM. EEPROM is a user-modifiable ROM that can be erased and reprogrammed repeatedly through the application of higher than normal electrical voltage. Unlike EPROM chips, EEPROMs do not need to be removed from the computer to be modified. However, an EEPROM chip must be erased and reprogrammed in its entirety, not selectively. Virtual memory. A memory management technique where secondary memory can be used as if it were a part of the main memory. Virtual memory uses hardware and software to enable a computer to compensate for physical memory shortages by temporarily transferring data from RAM to disk storage. Timeline of the history and evolution of computer memory In the early 1940s, memory was only available up to a few bytes of space. One of the more significant signs of progress during this time was the invention of acoustic delay line memory. This technology enabled delay lines to store bits as sound waves in mercury, and quartz crystals to act as transducers to read and write bits. This process could store a few hundred thousand bits. In the late 1940s, nonvolatile memory began to be researched, and magnetic-core memory -- which enabled the recall of memory after a loss of power -- was created. By the 1950s, this technology had been improved and commercialized and led to the invention of PROM in 1956. Magnetic-core memory became so widespread that it was the main form of memory until the 1960s. Metal-oxide-semiconductor field-effect transistors, also known as MOS semiconductor memory, was invented in 1959. This enabled the use of MOS transistors as elements for memory cell storage. MOS memory was cheaper and needed less power compared to magnetic-core memory. Bipolar memory, which used bipolar transistors, started being used in the early 1960s. In 1961, Bob Norman proposed the concept of solid-state memory being used on an integrated circuit (IC) chip. IBM brought memory into the mainstream in 1965. However, users found solid-state memory to be too expensive to use at the time compared to other memory types. Other advancements during the early to mid-1960s were the invention of bipolar SRAM, Toshiba's introduction of DRAM in 1965 and the commercial use of SRAM in 1965. The single-transistor DRAM cell was developed in 1966, followed by a MOS semiconductor device used to create ROM in 1967. From 1968 to the early 1970s, N-type MOS (NMOS) memory also started to become popularized. By the early 1970s, MOS-based memory started becoming much more widely used as a form of memory. In 1970, Intel had the first commercial DRAM IC chip. One year later, erasable PROM was developed and EEPROM was invented in 1972.